Debug Command-Info - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

AAA Commands

debug command-info

Enables or disables the command information mode in the CLI. When this mode is enabled, any command
entered on the command line will display information about the command rather than executing the
command.
debug command-info {enable | disable}
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
When the mode is enabled, any command entered will result in output similar to the one shown in the
Examples section below. Any commands entered when the mode is enabled are not executed. To return
to normal operating mode, enter debug command-info disable.
•
The command information mode is useful when setting privileges for users.
Examples
-> debug command-info enable
CLI command info mode on
-> vlan 2
PM family: VLAN
R/W mode: WRITE
-> ls
PM family: SYSTEM
R/W mode: READ
output definitions
PM family
R/W mode
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
Enables the debugging command information mode.
Disables the debugging command information mode.
default
disable
The partitioned management (PM) command family to which the com-
mand belongs.
Whether the current command is a read-only or a write command.
November 2009 page 43-77