Table of Contents
Advertisement
12.5.7 ip vrrp priority
This command sets the priority value for the virtual router configured on a specified interface. The priority of the interface is a
priority integer from 1 to 254. The parameter <vrid> is the virtual router ID which has an integer value ranges from 1 to 255.
▫
Default
100
▫
Format
ip vrrp <vrid> priority <1-254>
▫
Mode
Interface Config
12.5.7.1 no ip vrrp priority
This command sets the default priority value for the virtual router configured on a specified interface.
▫
Format
no ip vrrp <vrid> priority
▫
Mode
Interface Config
12.5.8 ip vrrp timers advertise
This command sets the frequency, in seconds, that an interface on the specified virtual router sends a virtual router
advertisement.
▫
Default
1
▫
Format
ip vrrp <vrid> timers advertise <1-255>
▫
Mode
Interface Config
12.5.8.1 no ip vrrp timers advertise
This command sets the default virtual router advertisement value for an interface.
▫
Format
no ip vrrp <vrid> timers advertise
▫
Mode
Interface Config
12.5.9 show ip vrrp interface stats
This command displays the statistical information about each virtual router configured on the switch.
▫
Format
show ip vrrp interface stats <slot/port> <vrid>
▫
Modes
Privileged EXEC
User EXEC
Uptime
Protocol
State Transitioned to
Master
Advertisement Received
Advertisement Interval
Errors
The time that the virtual router has been up, in days, hours, minutes and seconds.
Represents the protocol configured on the interface.
Represents the total number of times virtual router state has changed to MASTER.
Represents the total number of VRRP advertisements received by this virtual router.
Represents the total number of VRRP advertisements received for which advertisement
interval is different than the configured value for this virtual router.
448
User's Manual of WGS3-2820/WGS3-5220
Advertisement
Table of Contents
