Planet Networking & Communication WGS3-2820 User Manual page 125

factory default is enable.
STP Mode - The Spanning Tree Protocol Administrative Mode associated with the Port Channel. The possible
。
values are:
Disable - spanning tree is disabled for this Port Channel.
。
Enable - spanning tree is enabled for this Port Channel.
。
Participation - For each port specify whether it is to be included as a member of this Port Channel or not. The
。
default is exclude. There can be a maximum of 8 ports assigned to a Port Channel.
Non-Configurable Data
Slot.Port - Slot.Port identification of the Port Channel being configured. This field will not appear when a new Port
。
Channel is being created.
Link Status - Indicates whether the Link is up or down.
。
Port Channel Members - List of members of the Port Channel in slot.port form.
。
Membership Conflicts - Shows ports that are already members of other Port Channels. A port may only be a
。
member of one Port Channel at a time. If the entry is blank, it is not currently a member of any Port Channel.
4.3.6.3 Port Channel Status
Port Channel - The slot.port identification of the Port Channel.
。
Port Channel Name - The name of the Port Channel.
。
Port Channel Type - The type of this Port Channel.
。
Admin Mode - The Administrative Mode of the Port Channel, enable or disable.
。
Link Status - Indicates whether the Link is up or down.
。
STP Mode - The Spanning Tree Protocol Administrative Mode associated with the Port Channel. The possible
。
values are:
Disable - spanning tree is disabled for this Port Channel.
。
Enable - spanning tree is enabled for this Port Channel.
。
Figure 4-3-28 Port Channel Configuration
125
User's Manual of WGS3-2820/WGS3-5220