Table of Contents
Advertisement
▫
Spanning Tree Flag - May be enabled or disabled. The factory default is enabled. Indicates whether spanning tree traps
will be sent.
▫
Broadcast Storm Flag - May be enabled or disabled. The factory default is enabled. Indicates whether broadcast storm
traps will be sent.
▫
DVMRP Traps - May be enabled or disabled. The factory default is disabled. Indicates whether DVMRP traps will be sent.
▫
OSPF Traps - May be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps will be sent.
▫
PIM Traps - May be enabled or disabled. The factory default is disabled. Indicates whether PIM traps will be sent.
8.5.20 snmp-server community
This command adds (and names) a new SNMP community. A community name is a name associated with the switch and with a
set of SNMP managers that manage it with a specified privileged level. The length of name can be up to 16 case-sensitive
characters.
Note
Community names in the SNMP community table must be unique. If you make multiple entries using the same
:
community name, the first entry is kept and processed and all duplicate entries are ignored.
▫
Two default community names: Public and Private. You can replace these default community names with
Default
unique identifiers for each community. The default values for the remaining four community names are blank.
▫
Format
snmp-server community <name>
▫
Mode
Global Config
8.5.20.1 no snmp-server community
This command removes this community name from the table. The name is the community name to be deleted.
▫
Format
no snmp-server community <name>
▫
Mode
Global Config
8.5.21 snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The address is the associated community SNMP packet
sending address and is used along with the client IP mask value to denote a range of IP addresses from which SNMP clients
may use that community to access the device. A value of 0.0.0.0 allows access from any IP address. Otherwise, this value is
ANDed with the mask to determine the range of allowed client IP addresses. The name is the applicable community name.
▫
Default
0.0.0.0
▫
Format
snmp-server community ipaddr <ipaddr> <name>
▫
Mode
Global Config
8.5.21.1 no snmp-server community ipaddr
This command sets a client IP address for an SNMP community to 0.0.0.0. The name is the applicable community name.
▫
Format
no snmp-server community ipaddr <name>
▫
Mode
Global Config
User's Manual of WGS3-2820/WGS3-5220
342
Advertisement
Table of Contents
