Ip Pim-Trapflags - Planet Networking & Communication WGS3-2820 User Manual

▫
Mode Global Config

13.5.9 ip pim-trapflags

This command enables the PIM trap mode for both Sparse Mode (SM) and Dense Mode. (DM). Default disabled
▫
Format ip pim-trapflags
▫
Mode Global Config
no ip pim-trapflags
This command disables the PIM trap mode.
▫
Format no ip pim-trapflags
▫
Mode Global Config
13.5.10 ip pimsm staticrp
This command is used to create RP IP address for the PIM-SM router. The parameter <ipaddress> is the IP address of the RP.
The parameter <groupaddress> is the group address supported by the RP. The parameter <groupmask> is the group mask for
the group address.
▫
Default disabled
▫
Format ip pimsm staticrp <ipaddress> <groupaddress> <groupmask>
▫
Mode Global Config
no ip pimsm staticrp
This command is used to delete RP IP address for the PIM-SM router. The parameter <ipaddress> is the IP address of the RP.
The parameter <groupaddress> is the group address supported by the RP. The parameter <groupmask> is the group mask for
the group address.
▫
Format no ip pimsm staticrp <ipaddress> <groupaddress> <groupmask>
▫
Mode Global Config
13.5.11 ip pimsm register-rate-limit
This command the register threshold rate for PIM-SM..
▫
Default disabled
▫
Format ip pimsm register-rate-limit <0-2000>
▫
Mode Global Config
User's Manual of WGS3-2820/WGS3-5220
515