Planet Networking & Communication WGS3-2820 User Manual page 107

Selection Criteria
。 Unit/Slot/Port - Selects the interface to be configured.
Configurable Data
。 Port Security - Enables or disables the Port Security feature for the selected interface.
。 Maximum Dynamic MAC Addresses allowed - Sets the maximum number of dynamically learned MAC addresses
on the selected interface.
Add a static MAC address - Adds a MAC address to the list of statically locked MAC addresses for the selected
。
interface.
。 VLAN ID - Adds a corresponding VLAN ID for the MAC Address being added to the list of statically locked MAC
addresses for the selected interface.
。 Maximum static MAC Addresses allowed - Sets the maximum number of statically locked MAC addresses on the
selected interface.
。 Enable violation traps - Enables or disables the sending of new violation traps designating when a packet with a
disallowed MAC address is received on a locked port.
Command Buttons
Submit - Applies the new configuration and causes the changes to take effect. These changes will not be retained
。
across a power cycle unless a save configuration is performed.
Move - Converts a dynamically learned MAC address to a statically locked address. The Dynamic MAC address
。
entries are converted to Static MAC address entries in a numerically ascending order until the Static limit is reached.
The format of entering MAC Address should be xx : xx : xx : xx : xx : xx
Notice:
Figure 4-3-9 Port Security Interface Configuration
107
User's Manual of WGS3-2820/WGS3-5220