Table of Contents
Advertisement
macaddr The MAC address format is six hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
areaid Area IDs may be entered in dotted-decimal notation (for example, 0.0.0.1). An area ID of 0.0.0.0 is reserved for the
backbone. Area IDs have the same form as IP addresses, but are distinct from IP addresses. The IP network number of the
sub-netted network may be used for the area ID.
slot/port This parameter denotes a valid slot number and a valid port number. For example, 0/1 represents slot number 0 and
port number 1. The <slot/port> field is composed of a valid slot number and a valid port number separated by a forward slash (/).
logical slot/port This parameter denotes a logical slot number and logical port number assigned. This is applicable in the case
of a port-channel (LAG). The operator can use the logical slot number and the logical port number to configure the port-channel.
5.1.4 Conventions
1.
Network addresses are used to define a link to a remote host, workstation or network. Network addresses are shown using
the following syntax:
2.
Double quotation marks such as "System Name with Spaces" set off user defined strings. If the operator wishes to use
spaces as part of a name parameter then it must be enclosed in double quotation marks.
3.
Empty strings ("") are not valid user defined strings.
4.
Command completion finishes spelling the command when enough letters of a command are typed to uniquely identify the
command word. The command may be executed by typing <enter> (command abbreviation) or the command word may be
completed by typing the <tab> or <space bar> (command completion).
Address Type
A.B.C.D
ipaddr
YY:YY:YY:YY:YY:YY:
macaddr
5.
The value 'Err' designates that the requested value was not internally accessible. This should never happen and indicates
that there is a case in the software that is not handled correctly.
6.
The value of '-----' designates that the value is unknown.
5.1.5 Annotations
The CLI allows the user to type single-line annotations at the command prompt for use when writing test or configuration scripts
and for better readability. The exclamation point ('!') character flags the beginning of a comment. The comment flag character
can begin a word anywhere on the command line and all input following this character is ignored. Any command line that begins
with the character '!' is recognized as a comment line and ignored by the parser. Some examples are provided below:
! Script file for displaying the ip interface
! Display information about interfaces
show ip interface 0/1 !Displays the information about the first interface
! Display information about the next interface
show ip interface 0/2
! End of the script file
Format
0.0.0.0 to 255.255.255.255 (decimal)
Table 4-1 Network Address Syntax
313
User's Manual of WGS3-2820/WGS3-5220
Range
hexidecimal digit pairs
Advertisement
Table of Contents
