Speed; Speed All; Storm-Control Broadcast - Planet Networking & Communication WGS3-2820 User Manual

▫
ModeInterface Config

8.6.60 speed

This command sets the speed and duplex setting for the interface.
▫
Format speed {{100 | 10} {half-duplex | full-duplex} | 1000 fullduplex}
▫
ModeInterface Config
Acceptable values are:
100h 100BASE-T half-duplex
100BASE-T full duplex
100f
10BASE-T half duplex
10h
100BASE-T full duplex
10f

8.6.61 speed all

This command sets the speed and duplex setting for all interfaces.
▫
Format speed all {{100 | 10} {half-duplex | full-duplex} | 1000 fullduplex}
▫
Mode Global Config
Acceptable values are:
100h 100BASE-T half-duplex
100BASE-T full duplex
100f
10BASE-T half duplex
10h
100BASE-T full duplex
10f

8.6.62 storm-control broadcast

This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm recovery with high and low
thresholds is implemented.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet port exceeds the high
threshold percentage (as represented in "Broadcast Storm Recovery Thresholds" table) of the link speed, the switch discards
the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or less. The full implementation is
depicted in the "Broadcast Storm Recovery Thresholds" table.
▫
Format storm-control broadcast
▫
Mode Global Config
Link Speed
10M
100M
1000M
High
20
5
5
Table 7-1 Broadcast Storm Recovery Thresholds
368
User's Manual of WGS3-2820/WGS3-5220
Low
10
2
2