Spanning-Tree Forceversion - Planet Networking & Communication WGS3-2820 User Manual

▫
Format spanning-tree edgeport
▫
Mode Interface Config
11.1.12.1 no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal spanning tree.
▫
Format no spanning-tree edgeport
▫
Mode Interface Config

11.1.13 spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value. The Force Protocol Version can be one of the
following:
▫ 802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality supported)
▫ 802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality supported)
▫ 802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
▫
Default 802.1s
▫
Format spanning-tree forceversion <802.1d | 802.1w | 802.1s>
▫
Mode Global Config
11.1.13.1 no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value, i.e. 802.1s.
▫
Format no spanning-tree forceversion
▫
Mode Global Config
11.1.14 spanning-tree forward-time
This command sets the Bridge Forward Delay parameter to a new value for the common and internal spanning tree. The
forward-time value is in seconds within a range of 4 to 30, with the value being greater than or equal to "(Bridge Max Age / 2) +
1".
▫
Default 15
▫
Format spanning-tree forward-time <4-30>
▫
Mode Global Config
11.1.14.1 no spanning-tree forward-time
This command sets the Bridge Forward Delay parameter for the common and internal spanning tree to the default value, i.e. 15.
▫
Format no spanning-tree forward-time
▫
Mode Global Config
11.1.15 spanning-tree hello-time
This command sets the Hello Time parameter to a new value for the common and internal spanning tree. The hellotime <value>
is in whole seconds within a range of 1 to 10 with the value being less than or equal to "(Bridge Max Age / 2) - 1".
▫
Default 2
User's Manual of WGS3-2820/WGS3-5220
424