Table of Contents
Advertisement
no area virtual-link authentication
This command configures the default authentication type for the OSPF virtual interface identified by <areaid> and <neighbor>.
The <neighbor> parameter is the Router ID of the neighbor.
▫
Format
no area <areaid> virtual-link <neighbor> authentication
▫
Mode
Router OSPF Config
12.7.17 area virtual-link dead-interval (OSPF)
This command configures the dead interval for the OSPF virtual interface on the virtual interface identified by <areaid> and
<neighbor>. The <neighbor> parameter is the Router ID of the neighbor. The range for seconds is 1 to 65535.
▫
Default
40
▫
Format
area <areaid> virtual-link <neighbor> dead-interval <seconds>
▫
Mode
Router OSPF Config
no area virtual-link dead-interval
This command configures the default dead interval for the OSPF virtual interface on the virtual interface identified by <areaid>
and <neighbor>. The <neighbor> parameter is the Router ID of the neighbor.
▫
Format
no area <areaid> virtual-link <neighbor> dead-interval
▫
Mode
Router OSPF Config
12.7.18 area virtual-link hello-interval (OSPF)
This command configures the hello interval for the OSPF virtual interface on the virtual interface identified by <areaid> and
<neighbor>. The <neighbor> parameter is the Router ID of the neighbor. The range for <seconds> is 1 to 65535.
▫
Default
10
▫
Format
area <areaid> virtual-link <neighbor> hello-interval <1-65535>
▫
Mode
Router OSPF Config
no area virtual-link hello-interval
This command configures the default hello interval for the OSPF virtual interface on the virtual interface identified by <areaid>
and <neighbor>. The <neighbor> parameter is the Router ID of the neighbor.
▫
Format
no area <areaid> virtual-link <neighbor> hello-interval
▫
Mode
Router OSPF Config
12.7.19 area virtual-link retransmit-interval (OSPF)
This command configures the retransmit interval for the OSPF virtual interface on the virtual interface identified by <areaid> and
User's Manual of WGS3-2820/WGS3-5220
458
Advertisement
Table of Contents
