Planet Networking & Communication WGS3-2820 User Manual page 124

groups). If the group is defined as a LACP static link aggregationing group, then any extra ports selected are placed in a
standby mode for redundancy if one of the other ports fails. If the group is defined as a local static link aggregationing group,
then the number of ports must be the same as the group member ports.
4.3.6.1 Switch Configuration
Use this page to setup the port channel switch configuration.
Configurable Data
Static Capability Mode - May be enabled or disabled by selecting the corresponding line on the pulldown entry field.
。
The factory default is disabled. This field is non-configurable for read-only users.
Command Buttons
Submit - Update the switch with the values on this screen. If you want the switch to retain the new values across a
。
power cycle, you must perform a save.
Refresh - Refresh the data on the screen with the present state of the data in the switch.
。
4.3.6.2 Port Channel Configuration
Use this page to configure the link aggregation for gathering bandwidth.
Selection Criteria
Port Channel Name – You can use this screen to reconfigure an existing Port Channel, or to create a new one.
。
Use this pull-down menu to select one of the existing Port Channels, or select 'Create' to add a new one. There
can be a maximum of 6 Port Channels.
Configurable Data
Port Channel Name - Enter the name you want assigned to the Port Channel. You may enter any string of up to
。
15 alphanumeric characters. A valid name has to be specified in order to create the Port Channel.
Link Trap - Specify whether you want to have a trap sent when link status changes. The factory default is enable,
。
which will cause the trap to be sent.
Administrative Mode - Select enable or disable from the pull-down menu. When the Port Channel is disabled no
。
traffic will flow and LACPDUs will be dropped, but the links that form the Port Channel will not be released. The
Figure 4-3-27 Port Channel Switch Configuration
124
User's Manual of WGS3-2820/WGS3-5220