Planet Networking & Communication WGS3-2820 User Manual page 298

4.7.4.7 Mtrace Show
This screen displays the results of an mtrace command. The mtrace command is used to trace the path from source to a
destination branch for a multicast distribution tree.
Non-Configurable Data
Number of hops away from destination - The number of hops away from the destination.
o
IP address of intermediate router - The IP address of the intermediate router in the path being traced between
o
source and destination for the hop number in the previous field.
Multicast Protocol in use - The multicast protocol in use on this hop.
o
TTL Threshold - The time-to-live threshold on this hop.
o
Time taken to forward between hops - The time taken for the trace request to be forwarded from the previous hop
o
to this hop.
Command Buttons
New Mtrace - Redirect the web browser to the Mtrace Run screen so that you can initiate another mtrace command.
o
Refresh - Refresh the content of the screen with the latest data available on the router. Typically, it takes around 20
o
seconds to process the results after initiating mtrace command. You must refresh the screen to display the latest
results.
Figure 4-6-74 Mtrace Show
298
User's Manual of WGS3-2820/WGS3-5220