Serial Baudrate; Serial Timeout - Planet Networking & Communication WGS3-2820 User Manual

Note Changing the timeout value for active sessions does not become effective until the session is reaccessed. Any
:
keystroke will also activate the new timeout duration.
▫
Default 5
▫
Format remotecon timeout <0-160>
▫
Mode Privileged EXEC
8.5.9.1 no remotecon timeout
This command sets the remote connection session timeout value, in minutes, to the default.
Note Changing the timeout value for active sessions does not become effective until the session is reaccessed. Any
:
keystroke will also activate the new timeout duration.
▫
Default 5
▫
Format no remotecon timeout
▫
Mode Privileged EXEC

8.5.10 serial baudrate

This command specifies the communication rate of the terminal interface. The supported rates are 1200, 2400, 4800, 9600,
19200, 38400, 57600, 115200.
9600
Default
Format serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200}
Mode Line Config
8.5.10.1 no serial baudrate
This command sets the communication rate of the terminal interface to 9600.
▫
Format no serial baudrate
▫
Mode Line Config

8.5.11 serial timeout

This command specifies the maximum connect time (in minutes) without console activity. A value of 0 indicates that a console
can be connected indefinitely. The time range is 0 to 160.
▫
Default 5
▫
Format serial timeout <0 - 160>
▫
Mode Line Config
8.5.11.1 no serial timeout
This command sets the maximum connect time (in minutes) without console activity to 5.
▫
Format no serial timeout
▫
Mode Line Config
User's Manual of WGS3-2820/WGS3-5220
338