Planet Networking & Communication WGS3-2820 User Manual page 475

▫
Format show ip ospf neighbor [interface <slot/port>] [<ip-address>]
▫
Modes Privileged EXEC
▫
User EXEC
If you do not specify an IP address, a table with the following columns displays for all neighbors or the neighbor associated with
the interface that you specify:
Router ID
Priority
IP Address
Interface
State
Dead Time
Shows the 4-digit dotted-decimal number of the neighbor router.
Displays the OSPF priority for the specified interface. The priority of an interface is a
priority integer from 0 to 255. A value of '0' indicates that the router is not eligible to
become the designated router on this network.
Shows the IP address of the neighbor
Shows the interface of the local router in slot/port format
Shows the state of the neighboring routers. Possible values are:
initial state of the neighbor conversation - no recent information has
Down-
been received from the neighbor.
Neighbor no recent information has been received from the neighbor but a
Attempt -
more concerted effort should be made to contact the
an Hello packet has recently been seen from the neighbor, but bidirec tional
Init -
communication has not yet been established.
communication between the two routers is bidirectional.
2 way -
Exchange start - the first step in creating an adjacency between the two
neigh boring routers, the goal is to decide which router is the master and to
decide upon the initial DD sequence number.
Exchange - the router is describing its entire link state database by sending Database
Description packets to the neighbor.
Link State Request packets are sent to the neighbor asking for the more
Loading -
recent LSAs that have been discovered (but not yet received) in the
Exchange state
the neighboring routers are fully adjacent and they will now appear in
Full -
router-LSAs and network-LSAs
Shows the amount of time, in seconds, to wait before the router assumes the neighbor is
unreachable.
475
User's Manual of WGS3-2820/WGS3-5220