Arp Timeout - Planet Networking & Communication WGS3-2820 User Manual

▫
Mode Global Config

12.1.14 arp timeout

This command configures the ARP entry ageout time.
The value for <seconds> is a valid positive integer, which represents the IP ARP entry ageout time in seconds. The range for
<seconds> is between 15-21600 seconds.
▫
Default 1200
▫
Format arp timeout <15-21600>
▫
Mode Global Config
12.1.15 no arp timeout
This command configures the default ARP entry ageout time.
▫
Format no arp timeout
▫
Mode Global Config
12.1.16 clear arp-cache
This command causes all ARP entries of type dynamic to be removed from the ARP cache. If the gateway keyword is specified,
the dynamic entries of type gateway are purged as well.
▫
Format clear arp-cache [gateway]
▫
Mode Privileged EXEC
12.1.17 show arp
This command displays the Address Resolution Protocol (ARP) cache. The displayed results are not the total ARP entries. To
view the total ARP entries, the operator should view the show arp results in conjunction with the show arp switch results.
▫
Format show arp
▫
Mode Privileged EXEC
Age Time (seconds)
Response Time (seconds) Is the time it takes for an ARP request timeout. This value was configured into the unit.
Retries
Is the time it takes for an ARP entry to age out. This value was configured into the unit.
Age time is measured in seconds.
Response time is measured in seconds.
Is the maximum number of times an ARP request is retried. This value was configured into
the unit.
431
User's Manual of WGS3-2820/WGS3-5220