Table of Contents
Advertisement
3.11 LACP Commands
3.11.1 lacp system-priority
The lacp system-priority global configuration command configures the system priority. To reset to default, use the no
form of this command.
Syntax
lacp system-priority value
no lacp system-priority
§
value — Value of the priority. (Range: 1 - 65535)
Default Configuration
The default system priority value is 1.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the system priority to 120.
Console (config)# lacp system-priority 120
3.11.2 lacp port-priority
The lacp port-priority interface configuration command configures the priority value for physical ports. To reset to default
priority value, use the no form of this command.
Syntax
lacp port-priority value
no lacp port-priority
§
value — Port priority value. (Range: 1 - 65535)
Default Configuration
The default port priority value is 1.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the priority value for port g8 to 247.
Console (config)# interface ethernet g8
Console (config-if)# lacp port-priority 247
3.11.3 lacp timeout
The lacp timeout interface configuration command assigns an administrative LACP timeout. To reset the default
administrative LACP timeout use the no form of this command.
Syntax
lacp timeout {long | short}
no lacp timeout
75
Advertisement
Table of Contents
