Set Gvrp Interfacemode All; Show Description; Show Garp; Show Gmrp Configuration - Planet Networking & Communication WGS3-2820 User Manual

8.6.33 set gvrp interfacemode all

This command enables GVRP (GARP VLAN Registration Protocol) for all ports.
▫
Default Disabled
▫
Format set gvrp interfacemode all
▫
Mode Global Config
8.6.33.1 no set gvrp interfacemode all
This command disables GVRP (GARP VLAN Registration Protocol) for all ports. If GVRP is disabled, Join Time, Leave Time
and Leave All Time have no effect.
▫
Format no set gvrp interfacemode all
▫
Mode Global Config

8.6.34 show description

This command displays the port description information for one or all interfaces.
▫
Format show description {<slot/port> | all}
▫
Mode Privileged EXEC and User EXEC

8.6.35 show garp

This command displays Generic Attributes Registration Protocol (GARP) information.
▫
Format show garp
▫
Mode Privileged EXEC and User EXEC
▫ GMRP Admin Mode - This displays the administrative mode of GARP Multicast Registration Protocol (GMRP) for the
system.
▫ GVRP Admin Mode - This displays the administrative mode of GARP VLAN Registration Protocol (GVRP) for the
system.

8.6.36 show gmrp configuration

This command displays Generic Attributes Registration Protocol (GARP) information for one or all interfaces.
▫
Format show gmrp configuration {<slot/port> | all}
▫
Mode Privileged EXEC and User EXEC
▫ Interface - This displays the slot/port of the interface that this row in the table describes.
▫ Join Timer - Specifies the interval between the transmission of GARP PDUs registering (or re-registering) membership
for an attribute. Current attributes are a VLAN or multicast group. There is an instance of this timer on a per-Port,
per-GARP participant basis. Permissible values are 10 to 100 centiseconds (0.1 to 1.0 seconds). The factory default is 20
centiseconds (0.2 seconds). The finest granularity of specification is 1 centisecond (0.01 seconds).
▫ Leave Timer - Specifies the period of time to wait after receiving an unregister request for an attribute before deleting the
attribute. Current attributes are a VLAN or multicast group. This may be considered a buffer time for another station to
User's Manual of WGS3-2820/WGS3-5220
358