Shutdown; Shutdown All; Snmp Trap Link-Status; Snmp Trap Link-Status All - Planet Networking & Communication WGS3-2820 User Manual

8.6.53 shutdown

This command disables a port.
▫
Default Enabled
▫
Format shutdown
▫
Mode Interface Config
8.6.53.1 no shutdown
This command enables a port.
▫
Format no shutdown
▫
Mode Interface Config

8.6.54 shutdown all

This command disables all ports.
▫
Default Enabled
▫
Format shutdown all
▫
Mode Global Config
8.6.54.1 no shutdown all
This command enables all ports.
▫
Format no shutdown all
▫
Mode Global Config

8.6.55 snmp trap link-status

This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See 'snmpserverenable traps linkmode' command.
▫
Format snmp trap link-status
▫
Mode Interface Config
8.6.55.1 no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See 'snmpserver enable traps linkmode' command).
▫
Format no snmp trap link-status
▫
Mode Interface Config

8.6.56 snmp trap link-status all

This command enables link status traps for all interfaces.
User's Manual of WGS3-2820/WGS3-5220
366