No Arp - Planet Networking & Communication WGS3-2820 User Manual

Table of Contents

Advertisement

This chapter describes the routing commands available in the FASTPATH CLI.
The Routing Commands chapter contains the following sections:
"Address Resolution Protocol (ARP) Commands" on page 93
"IP Routing Commands" on page 98
"Router Discovery Protocol Commands" on page 106
"Virtual LAN Routing Commands" on page 108
"Virtual Router Redundancy Protocol Commands" on page 109
"DHCP and BOOTP Relay Commands" on page 114
"Open Shortest Path First (OSPF) Commands" on page 116
"Routing Information Protocol (RIP) Commands" on page 140
"Border Gateway Protocol (BGP) Commands" on page 149
The commands in this chapter are in one of three functional groups:
Show commands are used to display switch settings, statistics and other information.
Configuration Commands are used to configure features and options of the switch. For every configuration command
there is a show command that will display the configuration setting.
Clear commands clear some or all of the settings to factory defaults.
12.1 Address Resolution Protocol (ARP) Commands
This section describes the commands you use to configure ARP and to view ARP information on the switch. ARP associates IP
addresses with MAC addresses and stores the information as ARP entries in the ARP cache.
12.1.1 arp
This command creates an ARP entry. The value for <ipaddress> is the IP address of a device on a subnet attached to an
existing routing interface. <macaddr> is a unicast MAC address for that device.
The format of the MAC address is 6 two-digit hexadecimal numbers that are separated by colons, for example
00:06:29:32:81:40.
Format
arp <ipaddress> <macaddr>
Mode
Global Config

12.1.2 no arp

This command deletes an ARP entry. The value for <arpentry> is the IP address of the interface. The value for <ipaddress> is
the IP address of a device on a subnet attached to an existing routing interface. <macaddr> is a unicast MAC address for that
device.
Format
no arp <ipaddress> <macaddr>
User's Manual of WGS3-2820/WGS3-5220
12. CLI COMMANDS: Routing
428

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wgs3-5220

Table of Contents