Routing Information Protocol (Rip) Commands - Planet Networking & Communication WGS3-2820 User Manual

12.8 Routing Information Protocol (RIP) Commands

This section describes the commands you use to view and configure RIP, which is a distance-vector routing protocol that you
use to route traffic within a small network.
12.8.1 router rip
Use this command to enter Router RIP mode.
▫
Format router rip
▫
Mode Global Config
12.8.2 enable (RIP)
This command resets the default administrative mode of RIP in the router (active).
▫
Default enabled
▫
Format enable
▫
Mode Router RIP Config
no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
▫
Format no enable
▫
Mode Router RIP Config
12.8.3 ip rip
This command enables RIP on a router interface.
▫
Default disabled
▫
Format ip rip
▫
Mode Interface Config
no ip rip
This command disables RIP on a router interface.
▫
Format no ip rip
▫
Mode Interface Config
12.8.4 auto-summary
This command enables the RIP auto-summarization mode.
User's Manual of WGS3-2820/WGS3-5220
480