Open Shortest Path First (Ospf) Commands - Planet Networking & Communication WGS3-2820 User Manual

12.7 Open Shortest Path First (OSPF) Commands

This section describes the commands you use to view and configure OSPF, which is a link-state routing protocol that you use to
route traffic within a network.
12.7.1 router ospf
Use this command to enter Router OSPF mode.
▫
Format router ospf
▫
Mode Global Config
12.7.2 enable (OSPF)
This command resets the default administrative mode of OSPF in the router (active).
▫
Default enabled
▫
Format enable
▫
Mode Router OSPF Config
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
▫
Format no enable
▫
Mode Router OSPF Config
12.7.3 ip ospf
This command enables OSPF on a router interface.
▫
Default disabled
▫
Format ip ospf
▫
Mode Interface Config
no ip ospf
This command disables OSPF on a router interface.
▫
Format no ip ospf
▫
Mode Interface Config
12.7.4 1583compatibility
This command enables OSPF 1583 compatibility.
NOTE: 1583 compatibility mode is enabled by default. If all OSPF routers in the routing domain are capable of operating
User's Manual of WGS3-2820/WGS3-5220
453