Planet Networking & Communication WGS3-2820 User Manual page 56

This allows logging to any serial device attached to the host.
Configurable Data
。 Admin Status -A log that is "Disabled" shall not log messages. A log that is "Enabled" shall log messages. Enable or
Disable logging by selecting the corresponding line on the pulldown entry field.
。 Severity Filter - A log records messages equal to or above a configured severity threshold. Select the severity option
by selecting the corresponding line on the pulldown entry field. These severity levels have been enumerated below:
-Emergency
-Alert (1): action must be taken immediately
-Critical (2): critical conditions
-Error (3): error conditions
-Warning (4): warning conditions
-Notice(5): normal but significant conditions
-Informational(6): informational messages
-Debug(7): debug-level messages
4.2.5.6 Hosts Configuration
Configurable Data
。 Host - This is a list of the hosts that have been configured for syslog. Select a host for changing the configuration or
choose to add a new hosts from the drop down list.
。 IP Address - This is the ip address of the host configured for syslog.
(0): system is unusable
Figure 4-2-21 Event Log
Figure 4-2-22 Host Configuration
User's Manual of WGS3-2820/WGS3-5220
56