Planet Networking & Communication WGS3-2820 User Manual page 120

Configurable Data
。 VLAN ID - Specifies list of VLAN IDs for which IGMP Snooping is enabled.
。 VLAN ID - Appears when "New Entry" is selected in VLAN ID combo box. Specifies VLAN ID for which
pre-configurable Snooping parameters are to be set.
。 Admin Mode - Enable Igmp Snooping for the specified VLAN ID.
。 Fast Leave Admin Mode - Enable or disable the Igmp Snooping Fast Leave Mode for the specified VLAN ID.
。 Group Membership Interval - Sets the value for group membership interval of IGMP Snooping for the specified
VLAN ID.
Valid range is (Maximum Response Time + 1) to 3600.
。 Maximum Response Time - Sets the value for maximum response time of IGMP Snooping for the specified VLAN
ID.
Valid range is 1 to (Group Membership Interval - 1).
Its value should be greater than group membership interval value.
。 Multicast Router Expiry Time - Sets the value for multicast router expiry time of IGMP Snooping for the specified
VLAN ID.
Valid range is 0 to 3600.
Command Buttons
。 Submit - Update the switch with the values you entered.
。 Delete - Update the switch with the default values.
4.3.5.5 Multicast Router Statistics
Figure 4-3-22 IGMP Snooping VLAN Configuration
120
User's Manual of WGS3-2820/WGS3-5220