Planet Networking & Communication WGS3-2820 User Manual page 214

4.6.3.3 RIP Interface Configuration
Selection Criteria
Slot/Port - Select the interface for which data is to be configured.
。
Configurable Data
Send Version - Select the version of RIP control packets the interface should send from the pulldown menu. The
。
value is one of the following:
RIP-1 - send RIP version 1 formatted packets via broadcast.
RIP-1c - RIP version 1 compatibility mode. Send RIP version 2 formatted packets via broadcast.
RIP-2 - send RIP version 2 packets using multicast.
None - no RIP control packets will be sent.
The default is RIP-2.
Receive Version - Select what RIP control packets the interface will accept from the pulldown menu. The value is
。
one of the following:
RIP-1 - accept only RIP version 1 formatted packets.
RIP-2 - accept only RIP version 2 formatted packets.
Both - accept packets in either format.
None - no RIP control packets will be accepted.
The default is Both.
Figure 4-6-11 RIP Interface Configuation
214
User's Manual of WGS3-2820/WGS3-5220