Spanning-Tree Mst Vlan - Planet Networking & Communication WGS3-2820 User Manual

▫
Format spanning-tree mst priority <mstid>
▫
Mode Global Config

11.1.20 spanning-tree mst vlan

This command adds an association between a multiple spanning tree instance and a VLAN. The VLAN will no longer be
associated with the common and internal spanning tree. The instance <mstid> is a number that corresponds to the desired
existing multiple spanning tree instance. The <vlanid> corresponds to an existing VLAN ID.
▫
Format spanning-tree mst vlan <mstid> <vlanid>
▫
Mode Global Config
11.1.20.1 no spanning-tree mst vlan
This command removes an association between a multiple spanning tree instance and a VLAN. The VLAN will again be
associated with the common and internal spanning tree. The instance <mstid> is a number that corresponds to the desired
existing multiple spanning tree instance. The <vlanid> corresponds to an existing VLAN ID.
▫
Format no spanning-tree mst vlan <mstid> <vlanid>
▫
Mode Global Config
11.1.21 spanning-tree port mode
This command sets the Administrative Switch Port State for this port to enabled.
▫
Default Disabled
▫
Format spanning-tree port mode
▫
Mode Interface Config
11.1.21.1 no spanning-tree port mode
This command sets the Administrative Switch Port State for this port to disabled.
▫
Format no spanning-tree port mode
▫
Mode Interface Config
11.1.22 spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to enabled.
▫
Default Disabled
▫
Format spanning-tree port mode all
▫
Mode Global Config
11.1.22.1 no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
▫
Format no spanning-tree port mode all
▫
Mode Global Config
User's Manual of WGS3-2820/WGS3-5220
427