4.4.2.2 RADIUS Server Configuration
This page is to configure the RADIUS server connection features.
RADIUS Server IP Address - Selects the RADIUS server to be configured. Select add to add a server.
。
IP Address - The IP address of the server being added.
。
Port - The UDP port used by this server. The valid range is 0 - 65535.
。
Secret - The shared secret for this server. This is an input field only.
。
Apply - The Secret will only be applied if this box is checked. If the box is not checked, anything entered in the
。
Secret field will have no affect and will not be retained. This field is only displayed if the user has READWRITE
access.
Primary Server - Sets the selected server to thePrimary or Secondary server.
。
Message Authenticator - Enable or disable the message authenticator attribute for the selected server.
。
Current - Indicates if this server is currently in use as the authentication server.
。
Secret Configured - Indicates if the shared secret for this server has been configured.
。
Command Buttons
Submit - Send the updated screen to the switch and cause the changes to take effect on the switch but these
。
changes will not be retained across a power cycle unless a save is performed.
Remove - Remove the selected server from the configuration. This button is only available to READWRITE users.
。
These changes will not be retained across a power cycle unless a save is performed.
Refresh - Update the information on the page.
。
Figure 4-4-8 RADIUS Configuration
157
User's Manual of WGS3-2820/WGS3-5220