Planet Networking & Communication WGS3-2820 User Manual page 259

。 Advertise Address - Enter the IP Address to be used to advertise the router.
。 Maximum Advertise Interval - Enter the maximum time (in seconds) allowed between router advertisements sent
from the interface.
。 Minimum Advertise Interval - Enter the minimum time (in seconds) allowed between router advertisements sent
from the interface.
。 Advertise Lifetime - Enter the value (in seconds) to be used as the lifetime field in router advertisements sent from
the interface. This is the maximum length of time that the advertised addresses are to be considered as valid router
addresses by hosts.
。 Preference Level - Specify the preference level of the router as a default router relative to other routers on the
same subnet. Higher numbered addresses are preferred. You must enter an integer.
Command Buttons
。 Submit - Send the updated configuration to the switch. Configuration changes take effect immediately. The
changes will not be retained across a power cycle unless a save is performed.
User's Manual of WGS3-2820/WGS3-5220
259