Planet Networking & Communication WGS3-2820 User Manual page 263

。 VRID and Slot/Port - Select 'Create' from the pulldown menu to configure a new Virtual Router, or select one of the
existing Virtual Routers, listed by interface number and VRID.
Configurable Data
VRID - This field is only configurable if you are creating new Virtual Router, in which case enter the VRID in the
。
range 1 to 255 .
Slot/Port - This field is only configurable if you are creating new Virtual Router, in which case select the Slot/Port for
。
the new Virtual Router from the pulldown menu.
Pre-empt Mode - Select enable or disable from the pulldown menu. If you select enable a backup router will
。
preempt the master router if it has a priority greater than the master virtual router's priority provided the master is
not the owner of the virtual router IP address. The default is enable.
Priority - Enter the priority value to be used by the VRRP router in the election for the master virtual router. If the
。
Virtual IP Address is the same as the interface IP Address, the priority gets set to 255 no matter what the user
enters. If the user enters a priority of 255 when the Virtual and interface IP Addresses are not the same, the priority
gets set to the default value of 100.
Advertisement Interval - Enter the time, in seconds, between the transmission of advertisement packets by this
。
virtual router. Enter a number between 1 and 255. The default value is 1 second.
IP Address - Enter the IP Address associated with the Virtual Router. The default is 0.0.0.0.
。
Authentication Type - Select the type of Authentication for the Virtual Router from the pulldown menu. The default
。
is None. The choices are:
0-None - No authentication will be performed.
1-Simple - Authentication will be performed using a text password.
Authentication Data - If you selected simple authentication, enter the password.
。
Status - Select active or inactive from the pulldown menu to start or stop the operation of the Virtual Router. The
。
default is inactive.
Non-Configurable Data
Interface IP Address - Indicates the IP Address associated with the selected interface.
。
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect immediately. These
。
changes will not be retained across a power cycle unless a save is performed.
Delete - Delete the selected Virtual Router. Note that the router can not be deleted if there are secondary
。
addresses configured.
Secondary IP Address - Proceed to the Secondary IP Address configuration screen.
。
User's Manual of WGS3-2820/WGS3-5220
263