▫
Mode
Global Config
13.5.6 ip pimsm mode
This command sets administrative mode of PIM-SM multicast routing on a routing interface to enabled.
▫
Default
disabled
▫
Format
ip pimsm mode
▫
Mode
Interface Config
no ip pimsm mode
This command sets administrative mode of PIM-SM multicast routing on a routing interface to disabled.
▫
Format
no ip pimsm mode
▫
Mode
Interface Config
13.5.7 ip pimsm query-interval
This command configures the transmission frequency of hello messages in seconds between PIM enabled neighbors. This field
has a range of 10 to 3600 seconds.
▫
Default
30
▫
Format
ip pimsm query-interval <10-3600>
▫
Mode
Interface Config
no ip pimsm query-interval
This command resets the transmission frequency of hello messages between PIM enabled neighbors to the default value.
▫
Format
no ip pimsm query-interval
▫
Mode
Interface Config
13.5.8 ip pimsm spt-threshold
This command is used to configure the Threshold rate for the RP router to switch to the shortest path. The rate is specified in
Kilobytes per second. The possible values are 0 to 2000.
▫
Default
50
▫
Format
ip pimsm spt-threshold <0-2000>
▫
Mode
Global Config
no ip pimsm spt-threshold
This command is used to reset the Threshold rate for the RP router to switch to the shortest path to the default value.
▫
Format
no ip pimsm spt-threshold
User's Manual of WGS3-2820/WGS3-5220
514