Table of Contents
Advertisement
Opaque Link
Opaque Area
Subtotal
Total
12.7.48 show ip ospf interface
This command displays the information for the IFO object or virtual interface tables.
▫
Format
show ip ospf interface {<slot/port> | loopback <loopback-id>}
▫
Modes
Privileged EXEC
User EXEC
IP Address
Subnet Mask
OSPF Admin Mode
OSPF Area ID
Router Priority
Retransmit Interval
Hello Interval
Dead Interval
LSA Ack Interval
Transit Delay Interval
Authentication Type
The information below will only be displayed if OSPF is enabled.
OSPF Interface Type
link state database.
Number of opaque link LSAs in the database.
Number of opaque area LSAs in the database.
Number of entries for the identified area.
Number of entries for all areas.
Represents the IP address for the specified interface.
A mask of the network and host portion of the IP address for the OSPF inter
face.
States whether OSPF is enabled or disabled on a router interface.
Represents the OSPF Area Id for the specified interface.
A number representing the OSPF Priority for the specified interface.
A number representing the OSPF Retransmit Interval for the specified interface
A number representing the OSPF Hello Interval for the specified interface.
A number representing the OSPF Dead Interval for the specified interface.
A number representing the OSPF LSA Acknowledgement Interval for the specified
interface.
A number representing the OSPF Transit Delay for the specified interface.
The OSPF Authentication Type for the specified interface are: none, simple, and encrypt.
Broadcast LANs, such as Ethernet and IEEE 802.5, take the value broadcast. The OSPF
471
User's Manual of WGS3-2820/WGS3-5220
Advertisement
Table of Contents
