Dot1X System-Auth-Control - Planet Networking & Communication WGS3-2820 User Manual

▫
Mode Interface Config
10.1.11.1 no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
▫
Format no dot1x re-authentication
▫
Mode Interface Config

10.1.12 dot1x system-auth-control

This command is used to enable the dot1x authentication support on the switch. By default, the authentication support is
disabled. While disabled, the dot1x configuration is retained and can be changed, but is not activated.
▫
Default Disabled
▫
Format dot1x system-auth-control
▫
Mode Global Config
10.1.12.1 no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
▫
Format no dot1x system-auth-control
▫
Mode Global Config
10.1.13 dot1x timeout
▫ This command sets the value, in seconds, of the timer used by the authenticator state machine on this port. Depending on
the token used and the value (in seconds) passed, various timeout configurable parameters are set. The following tokens
are supported.
reauth-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to determine
when re-authentication of the supplicant takes place. The reauth-period must be a value in the range 1 - 65535.
▫ quiet-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to define
periods of time in which it will not attempt to acquire a supplicant. The quiet-period must be a value in the range 0 -
65535.
▫ tx-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to determine when
to send an EAPOL EAP Request/Identity frame to the supplicant. The quiet-period must be a value in the range 1 -
65535.
▫ supp-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to timeout the
supplicant. The supp-timeout must be a value in the range 1 - 65535.
▫ server-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to timeout
the authentication server. The supp-timeout must be a value in the range 1 - 65535.
▫ reauth-period: 3600 seconds
Default
quiet-period: 60 seconds
tx-period: 30 seconds
supp-timeout: 30 seconds
server-timeout: 30 seconds
User's Manual of WGS3-2820/WGS3-5220
407