Planet Networking & Communication WGS3-2820 User Manual page 317

Command
copy {
nvram:startup-config |
nvram:errorlog |
nvram:msglog |
nvram:traplog} <url>
Table 5-4 Quick Start up Uploading from Switch to Out-of-Band PC (XMODEM)
Quick Start up Downloading from Out-of-Band PC to Switch (Only XMODEM)
Command
copy <url>
{nvram:startup-config |
system: image}
Table 5-5 Quick Start up Downloading from Out-of-Band PC to Switch (Only XMODEM)
Quick Start up Downloading from TFTP Server
Before starting a TFTP server download, the operator must complete the Quick Start up for the IP Address.
Command
copy <url>
{nvram:startup-config |
system: image}
Quick Start up Factory Defaults
Command
The types are:
▫ config - configuration file
▫ errorlog - error log
▫ system trace - system trace
▫ traplog - trap log
The URL must be specified as:
▫ xmodem:filepath/fileName
This starts the upload and also displays the mode of uploading and the
type of upload it is and confirms the upload is taking place.
For example:
If the user is using HyperTerminal, the user must specify where the file is
going to be received by the PC.
Sets the destination (download) data type to be an image (system:image)
or a configuration file (nvram:startup-config).
The URL must be specified as:
xmodem:filepath/fileName
For example:
If the user is using HyperTerminal, the user must specify which file is to be
sent to the switch.
The Switch will restart automatically once the code has been downloaded.
Sets the destination (download) data type to be an image (system:image)
or a configuration file (nvram:startup-config).
The URL must be specified as:
tftp://ipAddr/filepath/fileName.
The nvram:startup-config option downloads the configuration file using tftp
and system:image option downloads the code file.
Table 5-6 Quick Start up Downloading from TFTP Server
User's Manual of WGS3-2820/WGS3-5220
Details
Details
Details
Details
317