No Arp Dynamicrenew - Planet Networking & Communication WGS3-2820 User Manual

12.1.8 no arp dynamicrenew

This command prevents dynamic ARP entries from renewing when they age out.
▫
Format no arp dynamicrenew
▫
Mode Privileged EXEC
12.1.9 arp purge
This command causes the specified IP address to be removed from the ARP cache. Only entries of type dynamic or gateway
are affected by this command.
▫
Format arp purge <ipaddr>
▫
Mode Privileged EXEC
12.1.10 arp resptime
This command configures the ARP request response timeout.
The value for <seconds> is a valid positive integer, which represents the IP ARP entry response timeout time in seconds. The
range for <seconds> is between 1-10 seconds.
▫
Default l
▫
Format arp resptime <1-10>
▫
Mode Global Config
12.1.11 no arp resptime
This command configures the default ARP request response timeout.
▫
Format no arp resptime
▫
Mode Global Config
12.1.12 arp retries
This command configures the ARP count of maximum request for retries.
The value for <retries> is an integer, which represents the maximum number of request for retries. The range for <retries> is an
integer between 0-10 retries.
▫
Default 4
▫
Format arp retries <0-10>
▫
Mode Global Config
12.1.13 no arp retries
This command configures the default ARP count of maximum request for retries.
▫
Format no arp retries
User's Manual of WGS3-2820/WGS3-5220
430