Vlan Tagging; User Account Management Commands; Disconnect; Show Loginsession - Planet Networking & Communication WGS3-2820 User Manual

▫
Format no vlan pvid <1-4094>
▫
Mode Interface Config

8.6.79 vlan tagging

This command configures the tagging behavior for a specific interface in a VLAN to enabled. If tagging is enabled, traffic is
transmitted as tagged frames. If tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN
identification number.
▫
Format vlan tagging <1-4094>
▫
Mode Interface Config
8.6.79.1 no vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to disabled. If tagging is disabled, traffic is
transmitted as untagged frames. The ID is a valid VLAN identification number.
▫
Format no vlan tagging <1-4094>
▫
Mode Interface Config

8.7 User Account Management Commands

These commands manage user accounts.

8.7.1 disconnect

This command closes a telnet session.
▫
Format disconnect {<sessionID> | all}
▫
Mode Privileged EXEC

8.7.2 show loginsession

This command displays current telnet and serial port connections to the switch.
▫
Format show loginsession
▫
Mode Privileged EXEC
▫
ID Login Session ID
▫ User Name - The name the user will use to login using the serial port or Telnet. A new user may be added to the switch by
entering a name in a blank entry. The user name may be up to 8 characters, and is not case sensitive. Two users are
included as the factory default, 'admin' and 'guest'.
▫ Connection From - IP address of the telnet client machine or EIA-232 for the serial port connection.
▫ Idle Time - Time this session has been idle.
▫ Session Time - Total time this session has been connected.

8.7.3 show users

This command displays the configured user names and their settings. This command is only available for users with readwrite
privileges. The SNMPv3 fields will only be displayed if SNMP is available on the system.
▫
Format show users
User's Manual of WGS3-2820/WGS3-5220
374