Planet Networking & Communication WGS3-2820 User Manual page 179

。 Destination MAC - Specifies the destination MAC address to compare against an Ethernet frame. Valid format is
(xx:xx:xx:xx:xx:xx). The BPDU keyword may be specified using a Destination MAC address of 01:80:C2:xx:xx:xx.
。 Ethertype Key - Specifies the Ethertype value to compare against an Ethernet frame.
Valid values are
。 Ethertype User Value - Specifies the user defined customised Ethertype value to be used when the user has
selected "User Value" as Ethertype Key, to compare against an Ethernet frame. Valid range of values is (0x0600 to
0xFFFF).
。 Source MAC - Specifies the Source MAC address to compare against an Ethernet frame. Valid format is
(xx:xx:xx:xx:xx:xx).
。 VLAN - Specifies the VLAN ID to compare against an Ethernet frame. Valid range of values is (0 to 4095). Either
VLAN Range or VLAN can be configured.
。 Match Every - Specifies an indication to match every Layer 2 MAC packet.
Valid values are
Command Buttons
。 Submit - Send the updated configuration to the switch. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.
。 Delete - Remove the currently selected Rule from the selected ACL. These changes will not be retained across a
power cycle unless a save configuration is performed.
Appletalk
ARP
IBM SNA
IPv4
IPv6
IPX
MPLS multicast
MPLS unicast
NetBIOS
Novell
PPPoE
Reverse ARP
User Value
True - Signifies that every packet is considered to match the selected ACL Rule.
False - Signifies that it is not mandatory for every packet to match the selected ACL Rule.
User's Manual of WGS3-2820/WGS3-5220
179