Planet Networking & Communication WGS3-2820 User Manual page 30

Remove the transceiver module
1. Make sure there is no network activity by consult or check with the network administrator. Or through the management
interface of the switch/converter (if available) to disable the port in advance.
2. Remove the Fiber Optic Cable gently.
3. Turn the handle of the MGB/MFB module to horizontal.
4. Pull out the module gently through the handle.
Never pull out the module without pull the handle or the push bolts on the module. Direct pull out the
Note
:
module with violent could damage the module and SFP module slot of the device.
Figure 2-7 Pull Out the SFP transceiver
30
User's Manual of WGS3-2820/WGS3-5220