This page includes the following fields:
Configurable Data
Admin Mode - Enable/Disable the operation of the CLI Command logging by selecting the corresponding pulldown
。
field and clicking Submit.
4.2.5.4 Console Log Configuration
This allows logging to any serial device attached to the host.
Configurable Data
。
Admin Status -A log that is "Disabled" shall not log messages. A log that is "Enabled" shall log messages. Enable
or Disable logging by selecting the corresponding line on the pulldown entry field.
。
Severity Filter - A log records messages equal to or above a configured severity threshold. Select the severity
option by selecting the corresponding line on the pulldown entry field. These severity levels have been enumerated
below:
-Emergency
-Alert
(1): action must be taken immediately
-Critical
-Error
(3): error conditions
-Warning
-Notice(5): normal but significant conditions
-Informational(6): informational messages
-Debug(7): debug-level messages
4.2.5.5 Event Log
Figure 4-2-19 Command Logger Configuration
(0): system is unusable
(2): critical conditions
(4): warning conditions
Figure 4-2-20 Console Log Configuration
User's Manual of WGS3-2820/WGS3-5220
55