Dot1X Port-Control - Planet Networking & Communication WGS3-2820 User Manual

10.1.8 dot1x port-control

This command sets the authentication mode to be used on the specified port. . The control mode may be one of the following.
▫ force-unauthorized: The authenticator PAE unconditionally sets the controlled port to unauthorized.
▫ force-authorized: The authenticator PAE unconditionally sets the controlled port to authorized.
▫ auto: The authenticator PAE sets the controlled port mode to reflect the outcome of the authentication exchanges
between the supplicant, authenticator and the authentication server.
▫
Default auto
▫
Format dot1x port-control {force-unauthorized | force-authorized | auto}
▫
Mode Interface Config
10.1.8.1 no dot1x port-control
This command sets the authentication mode to be used on the specified port to 'auto'.
▫
Format no dot1x port-control
▫
Mode Interface Config
10.1.9 dot1x port-control All
This command sets the authentication mode to be used on all ports. The control mode may be one of the following.
▫ force-unauthorized: The authenticator PAE unconditionally sets the controlled port to unauthorized.
▫ force-authorized: The authenticator PAE unconditionally sets the controlled port to authorized.
▫ auto: The authenticator PAE sets the controlled port mode to reflect the outcome of the authentication exchanges
between the supplicant, authenticator and the authentication server.
▫
Default auto
▫
Format dot1x port-control all {force-unauthorized | force-authorized | auto}
▫
Mode Global Config
10.1.9.1 no dot1x port-control All
This command sets the authentication mode to be used on all ports to 'auto'.
▫
Format no dot1x port-control all
▫
Mode Global Config
10.1.10 dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is only valid if the control mode for
the specified port is 'auto'. If the control mode is not 'auto' an error will be returned.
▫
Format dot1x re-authenticate <slot/port>
▫
Mode Privileged EXEC
10.1.11 dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
▫
Default Disabled
▫
Format dot1x re-authentication
User's Manual of WGS3-2820/WGS3-5220
406