Planet Networking & Communication WGS3-2820 User Manual page 226

Other Designated Router - The interface is connected to a broadcast or NBMA network on which other
routers have been selected to be the Designated Router and Backup Designated Router either. The router
attempts to form adjacencies to both the Designated Router and the Backup Designated Router.
The State is only displayed if the OSPF admin mode is enabled.
Designated Router - The identity of the Designated Router for this network, in the view of the advertising router.
。
The Designated Router is identified here by its router ID. The value 0.0.0.0 means that there is no Designated
Router. This field is only displayed if the OSPF admin mode is enabled.
。 Backup Designated Router - The identity of the Backup Designated Router for this network, in the view of the
advertising router. The Backup Designated Router is identified here by its router ID. Set to 0.0.0.0 if there is no
Backup Designated Router. This field is only displayed if the OSPF admin mode is enabled.
。 Number of Link Events - This is the number of times the specified OSPF interface has changed its state. This field
is only displayed if the OSPF admin mode is enabled.
Command Buttons
。 Configure Authentication - Display a new screen where you can select the authentication method for the virtual
link.
Submit - Send the updated configuration to the switch. Configuration changes take effect immediately. These
。
changes will not be retained across a power cycle unless a save is performed.
User's Manual of WGS3-2820/WGS3-5220
226