Table of Contents
Advertisement
External LSDB Limit
Default Metric
Default Route Advertise
Always
Metric
Metric Type
Maximum Paths
Redistributing
Source
Metric
Metric Type
Tag
Subnets
Distribute-List
12.7.42 show ip ospf abr
This command displays the internal OSPF routing table entries to Area Border Routers (ABR). This command takes no options.
▫
Format
show ip ospf abr
▫
Modes
Privileged EXEC
User EXEC
Type
Router ID
Cost
Shows the maximum number of non-default AS-external-LSAs entries that can be stored
in the link-state database.
Default value for redistributed routes.
Indicates whether the default routes received from other source protocols are advertised
or not
Shows whether default routes are always advertised.
Shows the metric for the advertised default routes. If the metric is not configured, this field
is blank.
Shows whether the routes are External Type 1 or External Type 2.
Shows the maximum number of paths that OSPF can report for a given destination.
This field is a heading and appears only if you configure the system to take routes learned
from a non-OSPF source and advertise them to its peers.
Shows source protocol/routes that are being redistributed. Possible values are static,
connected, BGP, or RIP.
Shows the metric of the routes being redistributed.
Shows whether the routes are External Type 1 or External Type 2.
Shows the decimal value attached to each external route.
For redistributing routes into OSPF, the scope of redistribution for the specified protocol.
Shows the access list used to filter redistributed routes.
The type of the route to the destination. It can be either:
▫
intra — Intra-area route
▫
inter — Inter-area route
Router ID of the destination
Cost of using this route
467
User's Manual of WGS3-2820/WGS3-5220
Advertisement
Table of Contents
