Command Buttons
Submit - Send the updated screen to the switch and cause the changes to take effect on the switch.
。
Delete - Remove the selected session configuration.
。
4.2.6.4 Periodic Port Mirroring
Use this page to configure the periodic port mirroring.
Selection Criteria
Session ID - A session ID can be selected. By default the First Session is selected.
。
Configurable Data
Peroidic Port Mirroring Mode - Specifies the Periodic Port Mirroring Mode for a selected session ID. By default
。
Periodic Port Mirroring Mode is Disabled.
Interval Time - Specifies the periodic port mirroring time interval in seconds.Default value is 30. Valid Range is (30
。
to 300).
Non-Configurable Data
Source Port - Specifies the mirrored port. This field is only visible when periodic port mirroring mode is enabled.
。
Source port changes periodically as per specified Interval Time.
Command Buttons
Submit - Send the updated screen to the switch and cause the changes to take effect on the switch.
。
Figure 4-2-30 Periodic Port Mirroring
63
User's Manual of WGS3-2820/WGS3-5220