Distance Ospf (Ospf) - Planet Networking & Communication WGS3-2820 User Manual

▫
Format default-metric <1-16777214>
▫
Mode Router OSPF Config
no default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.
▫
Format no default-metric
▫
Mode Router OSPF Config

12.7.23 distance ospf (OSPF)

This command sets the route preference value of OSPF in the router. Lower route preference values are preferred when
determining the best route. The type of OSPF can be intra, inter, type-1, or type-2. The OSPF specification (RFC 2328) requires
that preferences must be given to the routes learned via OSPF in the following order: intra < inter < type-1 < type-2. The
<preference> range is 1 to 255. A route with a preference of 255 cannot be used to forward traffic.
▫
Default intra—8
inter—10
type-1—13
type-2—50
▫
Format distance ospf {intra | inter | type1 | type2} <preference>
▫
Mode Router OSPF Config
no distance ospf
This command sets the default route preference value of OSPF in the router. The type of OSPF can be intra, inter, type-1, or
type-2.
▫
Format no distance ospf {intra | inter | type1 | type2}
▫
Mode Router OSPF Config
12.7.24 distribute-list out (OSPF)
Use this command to specify the access list to filter routes received from the source protocol.
▫
Format distribute-list <1-199> out {rip | bgp | static | connected}
▫
Mode Router OSPF Config
no distribute-list out
Use this command to specify the access list to filter routes received from the source protocol.
▫
Format no distribute-list <1-199> out {rip | bgp | static | connected}
▫
Mode Router OSPF Config
User's Manual of WGS3-2820/WGS3-5220
460