Planet Networking & Communication WGS3-2820 User Manual page 301

Slot/Port - Select the Slot and port for which data is to be displayed or configured. Slot 0 is the base unit. You must
o
have configured at least one router interface before configuring or displaying data for a PIM-DM interface, otherwise
an error message will be displayed.
Configurable Data
Interface Mode - Select enable or disable from the pulldown menu to set the administrative status of PIM-DM for the
o
selected interface. The default is disable.
Hello Interval - Enter the number of seconds between PIM hello messages transmitted from the selected interface.
o
The default value is 30. Valid values are from (10 to 3600) .
Command Buttons
Submit - Send the updated configuration to the router. Configuration changes take effect immediately. These
o
changes will not be retained across a power cycle unless a save is performed.
4.7.5.3 Help for PIM-DM Interface Summary
Selection Criteria
Figure 4-6-77 PIM-DM Interfaces Summary
301
User's Manual of WGS3-2820/WGS3-5220