Bootpdhcprelay Enable - Planet Networking & Communication WGS3-2820 User Manual

12.6.1.1 no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system.
▫
Format no bootpdhcprelay cidoptmode
▫
Mode Global Config

12.6.2 bootpdhcprelay enable

This command enables the forwarding of relay requests for BootP/DHCP Relay on the system.
▫
Default disabled
▫
Format bootpdhcprelay enable
▫
Mode Global Config
12.6.2.1 no bootpdhcprelay enable
This command disables the forwarding of relay requests for BootP/DHCP Relay on the system.
▫
Format no bootpdhcprelay enable
▫
Mode Global Config
12.6.3 bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP Relay on the system. The <hops>
parameter has a range of 1 to 16.
▫
Default 4
▫
Format bootpdhcprelay maxhopcount <1-16>
▫
Mode Global Config
12.6.3.1 no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/DHCP Relay on the system.
▫
Format no bootpdhcprelay maxhopcount
▫
Mode Global Config
12.6.4 bootpdhcprelay minwaittime
This command configures the minimum wait time in seconds for BootP/DHCP Relay on the system. When the BOOTP relay
agent receives a BOOTREQUEST message, it MAY use the seconds-since-client-began-booting field of the request as a factor
in deciding whether to relay the request or not. The parameter has a range of 0 to 100 seconds.
▫
Default 0
▫
Format bootpdhcprelay minwaittime <0-100>
▫
Mode Global Config
User's Manual of WGS3-2820/WGS3-5220
451