Planet Networking & Communication WGS3-2820 User Manual page 163

4.4.2.4 RADIUS Accounting Server Configuration
This page is to configure the RADIUS Accounting Server
Accounting Server IP Address - Selects the accounting server for which data is to be displayed or configured. If
。
the add item is selected, a new accounting server can be configured.
IP Address - The IP address of the accounting server to add. This field is only configurable if the add item is
。
selected.
Port - Specifies the UDP Port to be used by the accounting server. The valid range is 0 - 65535. If the user has
。
READONLY access, the value is displayed but cannot be changed.
Secret - Specifies the shared secret to use with the specfied accounting server. This field is only displayed if the
。
user has READWRITE access.
Apply - The Secret will only be applied if this box is checked. If the box is not checked, anything entered in the
。
Secret field will have no affect and will not be retained. This field is only displayed if the user has READWRITE
access.
Secret Configured - Indicates if the secret has been configured for this accounting server.
。
Command Buttons
Submit - Send the updated screen to the switch and cause the changes to take effect on the switch but these
。
changes will not be retained across a power cycle unless a save is performed.
Remove - Remove the selected accounting server from the configuration. This button is only available to
。
READWRITE users. These changes will not be retained across a power cycle unless a save is performed.
Refresh - Update the information on the page.
。
。
Figure 4-4-14 RADIUS Accounting Server Configuration
User's Manual of WGS3-2820/WGS3-5220
163