Table of Contents
Advertisement
1.2 How to use This Manual
This User Manual is structured as follows:
Section
2, Installation
The section explains the functions of the Switch and how to physically install the Switch.
Section
3, Configuration
The section contains the information about the software function of the Switch.
Section
4, Web Configuration
The section explains how to manage the switch by Web interface.
Section
5, Command Structure
The section explains how to manage the switch by Console interface..
Section
6, Quick Start Up
Section 7,
Mode-Base CLI
Section
8, CLI Command:-Base
Section
9, CLI Command: Quality of Service
Section
10, CLI Command: Security
Section
11, CLI Commands: Switching
Section
12, CLI Commands: Routing
Appendex A
The section contains cable information of the Switch.
1.3 Product Feature
Physical Ports
24/48 RJ-45 ports for 10/100Base-TX
4 RJ-45 ports for 10/100/1000Base-T
2 shared SFP mini-GBIC interfaces (Shared with Port-51 and Port-52)
One DB9 male/RS-232 console port
Layer 2 Features
Support auto MDI/MDI-X on all 10/100Base-TX and 10/100/1000Base-T ports
The 10/100Base-TX and 10/100/1000Base-T ports support auto-sensing, auto-negotiation
Supports Jumbo frame up to 9KB on 10/100/1000Base-T ports
Provides wire speed of L2 switching performance
Support sup to 16K MAC address entries
Supports Flow Control
− IEEE 802.1x for Full-Duplex mode
− Back-Pressure Flow Control in Half-Duplex mode
Provides Store-and-Forward forwarding scheme
Provides Broadcast storm protection
Supports IGMP snooping v1, v2
User's Manual of WGS3-2820/WGS3-5220
20
Advertisement
Table of Contents
