Virtual Lan Routing Commands - Planet Networking & Communication WGS3-2820 User Manual

12.4 Virtual LAN Routing Commands

This section describes the commands you use to view and configure VLAN routing and to view VLAN routing status information.
12.4.1 vlan routing
This command creates routing on a VLAN. The <vlanid> value has a range from 1 to 4094.
Format vlan routing <vlanid>
Mode VLAN Config
12.4.1.1 no vlan routing
This command deletes routing on a VLAN. The <vlanid> value has a range from 1 to 4094.
Format no vlan routing <vlanid>
Mode VLAN Config
12.4.2 show ip vlan
This command displays the VLAN routing information for all VLANs with routing enabled.
Format show ip vlan
Modes Privileged EXEC
User EXEC
MAC Address used by
Routing VLANs
VLAN ID
Logical Interface
IP Address
Subnet Mask
12.5 Virtual Router Redundancy Protocol Commands
This section describes the commands you use to view and configure Virtual Router Redundancy Protocol (VRRP) and to view
VRRP status information. VRRP helps provide failover and load balancing when you configure two devices as a VRRP pair.
12.5.1 ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the router. Default none
Is the MAC Address associated with the internal-bridge-router interface (IBRI). The same
MAC Address is used by all VLAN routing interfaces. It will be displayed above the
per-VLAN information.
Is the identifier of the VLAN.
Shows the logical slot/port associated with the VLAN routing interface.
Displays the IP Address associated with this VLAN.
Indicates the subnet mask that is associated with this VLAN
445
User's Manual of WGS3-2820/WGS3-5220