Planet Networking & Communication WGS3-2820 User Manual page 318

clear config
copy
system:running-config
nvram:startup-config
reload OR Cold Boot the
Switch
Enter yes when the prompt pops up to clear all the configurations
made to the switch.
Enter yes when the prompt pops up that asks if you want to save
the configurations made to the switch.
Enter yes when the prompt pops up that asks if you want to reset
the system.
This is the users choice either reset the switch or cold boot the
switch, both work effectively.
Table 5-7 Quick Start up Factory Defaults
User's Manual of WGS3-2820/WGS3-5220
318