Device Configuration Commands; Addport; Auto-Negotiate; Auto-Negotiate All - Planet Networking & Communication WGS3-2820 User Manual

8.6 Device Configuration Commands

8.6.1 addport

This command adds one port to the port-channel (LAG). The first interface is a logical slot and port number of a configured
port-channel.
▫
Format addport <logical slot/port>
▫
Mode Interface Config
Before adding a port to a port-channel, set the physical mode of the port. See 'speed' command.
Note
:

8.6.2 auto-negotiate

This command enables automatic negotiation on a port. The default value is enable.
▫
Format auto-negotiate
▫
Mode Interface Config
8.6.2.1 no auto-negotiate
This command disables automatic negotiation on a port.
▫
Format no auto-negotiate
▫
Mode Interface Config

8.6.3 auto-negotiate all

This command enables automatic negotiation on all ports. The default value is enable.
▫
Format auto-negotiate all
▫
Mode Global Config
8.6.3.1 no auto-negotiate all
This command disables automatic negotiation on all ports.
▫
Format no auto-negotiate all
▫
Mode Global Config

8.6.4 delete interface

This command deletes an existing port-channel (LAG) from the configuration. The interface is a logical slot and port for a
configured port-channel. The all option removes all configured port-channels (LAGs).
▫
Format delete interface { <logical slot/port> | all}
▫
ModeInterface Config
User's Manual of WGS3-2820/WGS3-5220
347