Table of Contents
Advertisement
▫
Mode
Privileged EXEC
▫
User Name - The name the user will use to login using the serial port, Telnet or Web. A new user may be added to the
switch by entering a name in a blank entry. The user name may be up to eight characters, and is not case sensitive. Two
users are included as the factory default, 'admin' and 'guest'.
▫
Access Mode - Shows whether the operator is able to change parameters on the switch (Read/Write) or is only able to
view them (Read Only). As a factory default, the 'admin' user has Read/Write access and the 'guest' has Read Only
access. There can only be one Read/Write user and up to five Read Only users.
▫
SNMPv3 AccessMode - This field displays the SNMPv3 Access Mode. If the value is set to Read-Write, the SNMPv3
user will be able to set and retrieve parameters on the system. If the value is set to ReadOnly, the SNMPv3 user will only
be able to retrieve parameter information. The SNMPv3 access mode may be different than the CLI and Web access
mode.
▫
SNMPv3 Authentication - This field displays the authentication protocol to be used for the specified login user.
▫
SNMPv3 Encryption - This field displays the encryption protocol to be used for the specified login user.
8.7.4 users name
This command adds a new user (account) if space permits. The account <username> can be up to eight characters in length.
The name may be comprised of alphanumeric characters as well as the dash ('-') and underscore ('_'). The <username> is not
case-sensitive.
Six user names can be defined.
▫
Format
users name <username>
▫
Mode
Global Config
8.7.4.1 no users name
This command removes an operator.
▫
Format
no users name <username>
▫
Mode
Global Config
Note
The 'admin' user account cannot be deleted.
:
8.7.5 users passwd
This command is used to change a password. The password should not be more than eight alphanumeric characters in length.
If a user is authorized for authentication or encryption is enabled, the password must be at least eight alphanumeric characters
in length. The username and password are not case sensitive when a password is changed, a prompt will ask for the former
password. If none, press enter.
▫
Default
No Password
▫
Format
users passwd <username>
▫
Mode
Global Config
8.7.5.1 no users passwd
This command sets the password of an existing operator to blank. When a password is changed, a prompt will ask for the
User's Manual of WGS3-2820/WGS3-5220
375
Advertisement
Table of Contents
